Aqua Insta Plug is a cementitious dry powder with special selected additives with exceptionally good fast setting and strength developing characteristics. It needs only addition of water to produce ultra rapid set plugging mortar.

WHERE TO USE: Can be effectively used in number of situations where very quick setting is required. It is used for plugging running leaks from concrete structure, basement, cellars, bricks, tunnels and joints of masonry of water storage reservoirs. For patching, caulking, joint filling, pointing and waterproofing of concrete segments, sewage systems, pipes, well foundations and mines.

HOW TO USE:
(A) PREPARATION: Area to be plugged should be cut back up to 15mm & given good mechanical key. Do not feather edge. Surfaces should be brushed cleaned to remove loose material, dust and grease contaminations by de-greasing. All surfaces must be damped down with clean water prior the application of Aqua Insta Plug.

(B) MIXING: Aqua Insta Plug has to be used after mixing with gauge water depending upon its application. As a guide line the water powder ratio to be mixed as explained below:-

• For anchoring plugging (Pourable consistency): 2 pbw of Aqua Insta Plug and 1 pbw of water.
• For filling cracks and holes to prevent water peculations (Filling consistency): 3 pbw of Aqua Insta Plug and 1 pbw of water.
• For casting machinery foundation (Flowing consistency): 3 pbw of Aqua Insta Plug and 2 pbw of water.

(C) APPLICATION: It has to be quickly used for mixing because it starts hardening within few minutes. Add water in one go. Do not re-temper. Mix only as much material as required for the immediate application.